How Much Oil Does A 2018 Jeep Compass Take: Oil Capacity
Reading Time: 5 minutes Introduction
For a U.S.-market 2018 Jeep Compass with the 2.4-liter engine, the oil capacity is 5 U.S. quarts (4.7 liters) when you replace the oil filter. Use SAE 0W-20 full-synthetic oil that meets FCA Material Standard MS-6395.
The five-quart figure is the engine’s service capacity, not a command to pour all five quarts in at once. Add oil in stages, then check the dipstick on level ground to avoid overfilling.
Oil Capacity and Type for a 2018 Jeep Compass
The U.S. 2018 Compass uses a 2.4-liter four-cylinder gasoline engine. For that engine, the listed oil capacity is 5 quarts with a new oil filter. Front-wheel drive and four-wheel drive do not change this capacity.
| Item | Specification |
|---|---|
| Engine covered | 2.4-liter four-cylinder gasoline engine |
| Oil capacity with filter | 5 U.S. qt (4.7 L) |
| Recommended viscosity | SAE 0W-20 |
| Oil requirement | Full synthetic meeting FCA MS-6395 |
Check the oil container label for the required standard, not just the viscosity. If the exact oil is not available, check the owner’s manual before using a different grade or product. Do not add oil additives unless the manual calls for them.
These specifications apply to the U.S.-market 2.4-liter Compass. If your vehicle was built for another market or has a different engine, confirm its specifications in the manual for that vehicle. You can find the handbook through the Mopar owner’s manual portal.
How to Add Oil Without Overfilling
Use the five-quart capacity as a guide, then let the dipstick set the final level. A small amount of old oil may remain in the engine after draining, so the amount needed for a refill can vary.
- Park on level ground and turn off the engine.
- If you are changing the oil, drain it and replace the oil filter. Follow the service steps in the owner’s manual.
- Add about 4 quarts of the correct oil.
- Wait a few minutes, then check the dipstick. Pull it out, wipe it clean, insert it fully, and check the level again.
- Add oil in small amounts until the level is within the dipstick’s marked range. Do not fill above the upper mark.
- If you changed the oil, start the engine briefly and check for leaks around the drain plug and filter. Turn the engine off, wait a few minutes, and check the dipstick again.
If the oil level is still low, add a little more and recheck. If it is above the marked range, do not keep driving until the excess oil is removed. Too much oil can harm the engine.
Common Oil-Change Questions and Mistakes
A new filter is included in the five-quart service capacity. If you do not replace the filter, the amount needed may differ, so use the dipstick rather than relying on a fixed refill amount.
Do not assume that every bottle labeled “0W-20” meets the required standard. Check the oil label for FCA MS-6395, and confirm the current requirement in the owner’s manual if you are unsure. Also, do not treat the engine’s capacity as the amount to add before checking the level.
After an oil change, reset the oil-life indicator using the procedure in the owner’s manual or the vehicle’s display menu. Reset it only after the service is complete; resetting the reminder does not change the oil or repair an oil leak.
FAQs
Does a 2018 Jeep Compass take 5 quarts with the filter?
Yes. The 2.4-liter U.S.-market model has a listed service capacity of 5 U.S. quarts (4.7 liters) with a new oil filter. Check the dipstick after filling.
What oil does a 2018 Jeep Compass use?
Use SAE 0W-20 full-synthetic oil that meets FCA MS-6395, as specified for the U.S.-market 2.4-liter engine. Check the manual for your vehicle if it has a different engine or market specification.
Does four-wheel drive change the oil capacity?
No. For the U.S. 2.4-liter engine, the oil capacity is the same for front-wheel-drive and four-wheel-drive models.
Should I pour in all five quarts at once?
No. Add most of the oil first, then check the dipstick and top up in small amounts. The actual refill can vary if some oil remains in the engine.
When should I change the oil?
Follow the vehicle’s oil-life indicator and the maintenance schedule in the owner’s manual. Do not exceed the manual’s stated time or mileage limit, and check the manual for any shorter interval that applies to your driving conditions.
Conclusion
A U.S.-market 2018 Jeep Compass with the 2.4-liter engine takes 5 quarts of SAE 0W-20 full-synthetic oil meeting FCA MS-6395 when the filter is changed. Add oil gradually, check the dipstick on level ground, and stop at the marked range. For a different engine or market version, verify the specification in that vehicle’s owner’s manual.
Sources
- Mopar owner’s manual portal — select the manual for the exact vehicle.
- NHTSA vehicle information — vehicle reference page.
