What Kind Of Oil Does A 2020 Jeep Compass Take: Oil Guide
Reading Time: 5 minutes For a U.S.-market 2020 Jeep Compass with the 2.4L engine, use SAE 0W-20 engine oil that meets FCA Material Standard MS-6395. The oil capacity is 5 quarts (4.7 liters) with a filter change. Check the dipstick after filling; the stated capacity is a guide, not a reason to overfill the engine.
This guide covers the U.S. model. If your Compass was built for another market or has a different engine, confirm the oil details in the owner’s manual for your vehicle.
Oil type and specification
The 2020 Compass owner’s manual specifies SAE 0W-20 oil that meets FCA MS-6395 for the U.S.-market 2.4L engine. SAE 0W-20 is the oil’s viscosity grade: it describes how the oil flows at cold start and at operating temperature.
When buying oil, check the label for both the 0W-20 grade and the required FCA standard. Do not choose oil by brand alone. If you are unsure whether a product meets the standard, check its label or ask the oil maker.
The Mopar owner’s manual page lets you look up the manual for your vehicle. The manual is the best source if the oil-fill cap, engine, or vehicle market differs from the details here.
How much oil does a 2020 Jeep Compass need?
The listed engine-oil capacity is 5 quarts (4.7 liters) when changing the oil filter. That is the service-fill capacity, not a direction to pour all five quarts in at once.
| Service detail | Specification |
|---|---|
| Engine oil | SAE 0W-20 meeting FCA MS-6395 |
| Capacity with filter change | 5 qt (4.7 L) |
| Engine in the U.S. model covered here | 2.4L four-cylinder |
After draining the old oil and fitting the new filter, add oil gradually. Then check the dipstick on level ground and bring the level into the marked range. The amount needed can vary slightly with how fully the old oil drained.
How to check and top up the oil
Check the oil on level ground, with the engine off. If the engine has been running, let it sit for a few minutes so oil can drain back into the sump.
- Pull out the dipstick and wipe it clean.
- Push it fully back in, then pull it out again.
- Read the level against the marks on the dipstick.
- If the level is low, add a small amount of the specified oil.
- Wait briefly, then check again. Stop when the level is in range.
Add oil in small steps rather than pouring in a full quart. Too much oil can harm the engine. If the level drops again soon after topping up, look for a leak or have a qualified technician check the vehicle.
When should you change the oil?
Follow the Compass oil-life or service reminder and the schedule in your owner’s manual. The manual says not to exceed 10,000 miles or 12 months, whichever comes first. The reminder may call for service sooner.
Frequent short trips, long periods of idling, dusty roads, or other demanding use can affect maintenance needs. Check the manual’s maintenance schedule for your driving conditions rather than relying on a single interval for every driver.
Common oil mistakes to avoid
- Using the wrong viscosity: The listed grade is 0W-20. Do not switch grades based only on weather or a suggestion for a different vehicle.
- Ignoring the FCA standard: A bottle marked 0W-20 may not state that it meets MS-6395. Check both requirements.
- Filling by capacity alone: The 5-quart figure is a reference. Use the dipstick to confirm the final level.
- Overfilling: Keep the oil between the dipstick marks. More oil is not better.
- Assuming every Compass is the same: Check the manual for your exact vehicle if the engine, market, or oil-fill information differs.
Frequently asked questions
Can I use synthetic oil in a 2020 Jeep Compass?
Yes, if the oil is SAE 0W-20 and meets FCA MS-6395. The key is meeting the grade and specification, not whether the bottle says “synthetic.”
Can I use 5W-20 instead of 0W-20?
Use the specified 0W-20 oil. Do not substitute another grade unless the owner’s manual for your exact vehicle or a qualified service professional confirms it is appropriate.
Do I need to replace the oil filter during an oil change?
The capacity listed above assumes a filter change. Use a filter made for the vehicle and follow the filter maker’s fitting instructions or have a technician do the service.
Should I pour in all 5 quarts after draining the oil?
No. Add oil gradually, then check the dipstick. The amount left in the engine after draining can vary, so the dipstick—not the bottle count—shows when the level is right.
Bottom line
For a U.S.-market 2020 Jeep Compass with the 2.4L engine, choose SAE 0W-20 oil that meets FCA MS-6395. The listed capacity is 5 quarts with a filter change. Confirm the final level on the dipstick, and use the vehicle’s owner’s manual and service reminder to guide maintenance.
